Don't you hate it when you glue down a component, only to discover that one of the wires (one now cover with glue) is just that little bit too short.

Happily my SPI Flash EEPROMs finally turned up today. So I figured the best place to stick one, was inside one of the RoboPanda's cartridges. Its a tight fit, but there is just enough room. The jumpers are to allow me to allocate the chip select line to either the original ROM, or the new chip. Unfortunately, after I hot glued down the jumpers, I discovered that one on the wires was just a tiny bit to short, and the solder joint is unfortunately embedded in the hot glue. Oh well, thats a problem for tomorrow.

This is a photo from yesterday that I didn't actually have time to upload. I haven't done anything physical with this today, but I did get the basic software written, I just didn't get around to testing it yet. Something else to do tomorrow.